Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ambient Lighting
The ambient lighting system consists of the ambient lighting switch, the ambient lighting module, and the harness with hard-wired LEDs located within the front and rear footwells, the floor console cup holders, the storage tray and the storage bin. The ambient lighting is powered on when the ignition key is in the RUN or ACCESSORY position. The ambient lighting switch is used to cycle the LEDs through 7 different color combinations or to turn the ambient lighting off. The ambient lighting module provides the necessary voltage to the LEDs to illuminate the cup holders, the storage tray bin and the front and rear footwell areas.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.