Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1063 (VEHICLE DYNAMIC SYSTEMS)
2009 Ford Fusion SEL, 3.0 1, FWD
Section 1063 (Vehicle Dynamic Systems)
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Section 1063 (Vehicle Dynamic Systems)
WARNING: This page is about a different car, the 2008 Mercury Milan, 2008 Lincoln MKZ, and 2008 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnostic Tests
- Anti-Lock Control
- Notes
- Principles of Operations
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: DTC B1483 - Brake Pedal Input Open Circuit
- Pinpoint Test B: DTC B1676 - Battery Pack Voltage Out of Range
- Pinpoint Test C: DTCs C1145, C1155, C1165 and C1175 - Wheel Speed Sensor Input Circuit Failure
- Pinpoint Test D: DTCs C1233, C1234, C1235 and C1236 - Wheel Speed Sensor Signal Fault
- Pinpoint Test E: DTC C1095 - ABS Hydraulic Pump Motor Circuit Failure
- Pinpoint Test F: Poor Vehicle Tracking During Anti-Lock Function
- Pinpoint Test G: The Traction Control System Cannot Be Disabled
- Anti-Lock Control
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.