Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1003 (EXTERIOR LIGHTING SYSTEM)
2009 Ford Fusion SEL, 3.0 1, FWD
Section 1003 (Exterior Lighting System)
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Section 1003 (Exterior Lighting System)
WARNING: This page is about a different car, the 2008 Mercury Milan, 2008 Lincoln MKZ, and 2008 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnostic Tests
- Headlamps
- Notes
- Principles of Operation
- Inspection and Verification
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: Both Low Beams Are Inoperative
- Pinpoint Test B: Both High Beams Are Inoperative
- Pinpoint Test C: One Low Beam Headlamp Is Inoperative
- Pinpoint Test D: One High Beam Headlamp Is Inoperative
- Pinpoint Test E: The Headlamps Are On Continuously
- Pinpoint Test F: The Flash-To-Pass Feature Is Inoperative
- AUTOLAMPS
- Stoplamp
- Turn Signal and Hazard Lamps
- Notes
- Principles of Operation
- Inspection and Verification
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Parking, Rear and License Plate Lamps
- Fog Lamps
- Reversing Lamps
- Daytime Running Lamps (DRL)
- Headlamps
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.