DTC P2015: - Intake Manifold Runner Position Sensor/Switch Circuit Range/Performance (Bank 1)

2009 Ford Fusion SEL, 3.0 1, FWDSECTION DTC P2015: - Intake Manifold Runner Position Sensor/Switch Circuit Range/Performance (Bank 1)
DTC P2015: - INTAKE MANIFOLD RUNNER POSITION SENSOR/SWITCH CIRCUIT RANGE/PERFORMANCE (BANK 1)

Description:  The intake manifold runner control (IMRC) system is monitored for failures. Each DTC distinguishes the corresponding bank. The test fails when the system detects the presence of a broken or persistently out of range linkage.
Possible Causes: 
  • Mechanical concern - bind, seize, damage, or obstruction of IMRC hardware
Diagnostic Aids: 
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test HU .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.