Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISDTC P1900: - OUTPUT SHAFT SPEED (OSS) SENSOR CIRCUIT INTERMITTENT
2009 Ford Fusion SEL, 3.0 1, FWD
DTC P1900: - Output Shaft Speed (OSS) Sensor Circuit Intermittent
2009 Ford Fusion SEL, 3.0 1, FWDSECTION DTC P1900: - Output Shaft Speed (OSS) Sensor Circuit Intermittent
DTC P1900: - OUTPUT SHAFT SPEED (OSS) SENSOR CIRCUIT INTERMITTENT
| Description: | The OSS sensor signal to the powertrain control module (PCM) is irregular or interrupted. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify harness and connector integrity. Verify correct installation of the OSS sensor. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Manual Transmission | GO to Pinpoint Test DP . | ||
| Automatic Transmission | Refer to the AUTOMATIC TRANSAXLE/TRANSMISSION - 5R55S , Automatic Transmission Cooling Symptom Chart, Pinpoint Test Output Shaft Speed Sensor to continue diagnosis. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.