DTC P1651: - Power Steering Pressure (PSP) Switch Input

2009 Ford Fusion SEL, 3.0 1, FWDSECTION DTC P1651: - Power Steering Pressure (PSP) Switch Input
DTC P1651: - POWER STEERING PRESSURE (PSP) SWITCH INPUT

Description:  The powertrain control module (PCM) counts the number of vehicle speed transitions from 0 to a calibrated speed. After a calibrated number of speed transitions, the PCM expects the PSP input to change. This DTC is set if the transition is not detected.
Possible Causes: 
  • Vehicle towed with the engine running
  • The power steering hydraulic concern was repaired but the DTC was not erased
  • PSP switch/shorting bar damaged
  • SIG RTN circuit open
  • PSP circuit open or shorted to SIGRTN
Diagnostic Aids:  Check if the vehicle was towed or a power steering repair was carried out. Observe the PSP PID while checking the wires for intermittent concerns.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All - - GO to Pinpoint Test FF .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.