Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0704: - Clutch Switch Input Circuit
2009 Ford Fusion SEL, 3.0 1, FWDSECTION DTC P0704: - Clutch Switch Input Circuit
DTC P0704: - CLUTCH SWITCH INPUT CIRCUIT
| Description: | When the clutch pedal is applied the voltage goes to low. If the powertrain control module (PCM) does not see this change from high to low the DTC is set. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | When the clutch pedal is applied and then released, the switch voltage should cycle. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test TA . | - | GO to Pinpoint Test TA . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.