Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009FUSION SEL, 3.0 1, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSHANDLES, LOCKS, LATCHES & ENTRY SYSTEMSGENERAL PROCEDURESKEYLESS ENTRY KEYPAD CODE PROGRAMMING
2009 Ford Fusion SEL, 3.0 1, FWD
Keyless Entry Keypad Code Programming
2009 Ford Fusion SEL, 3.0 1, FWDSECTION Keyless Entry Keypad Code Programming
NOTE:
To associate a memory configuration to a personal entry code, refer to the Owner's Literature.
- Enter the permanent factory keyless entry keypad code.
- Press the 1/2 button within 5 seconds to activate the programming mode.
- Within 5 seconds, enter the new 5-digit keyless entry keypad code. The doors lock and unlock to confirm the new code is programmed.
NOTE:
Holding the 1/2 button for more than 2 seconds after activation erases all the customer codes. The existing code does not need to be erased to program a new code.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.