Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009EDGE SPORT, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORSWITCHES
2009 Ford Edge Sport, FWD
Electrical Component Locator: Switches
2009 Ford Edge Sport, FWDSECTION Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| Anti-Theft Hood Switch | Right front of engine compartment. See Figure. |
| Brake Fluid Level Switch (Edge) | Master cylinder reservoir. See Figure. |
| Brake Fluid Level Switch (MKX) | Master cylinder reservoir. See Figure. |
| Brake Pedal Position (BPP) Switch (Edge) | Brake pedal support bracket. See Figure. |
| Brake Pedal Position (BPP) Switch (MKX) | Brake pedal support bracket. See Figure. |
| Ignition Switch | Steering column. See Figure. |
| Inertia Fuel Shutoff (IFS) Switch | Left "D" pillar. See Figure. |
| Liftgate Ajar Switch (Edge) | Lower right of liftgate. See Figure. |
| Liftgate Ajar Switch (MKX) | Lower right of liftgate. See Figure. |
| Multifunction Switch | Top of steering column. See Figure. |
| Oil Pressure Switch | Lower left of engine. See Figure. |
| Parking Brake Switch | Top of parking brake lever bracket. See Figure. |
| Power Steering Pressure Switch (Edge) | Right front of engine. See Figure. |
| Power Steering Pressure Switch (MKX) | Right front of engine. See Figure. |
| Safety Belt Buckle Switch (Driver) | Integral to driver's seat belt buckle. See Figure. |
| Safety Belt Buckle Switch (Passenger Side) | Integral to front passenger's seat belt buckle. See Figure. |
| Washer Fluid Level Switch (Edge) | Washer fluid reservoir. See Figure. |
| Washer Fluid Level Switch (MKX) | Washer fluid reservoir. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.