Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009EDGE SPORT, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 888 (ELECTRONIC ENGINE CONTROL SYSTEM)
2009 Ford Edge Sport, FWD
Section 888 (Electronic Engine Control System)
2009 Ford Edge Sport, FWDSECTION Section 888 (Electronic Engine Control System)
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnostic Tests
- Removal And Installation
- Camshaft Position (CMP) Sensor - 2.3L
- Camshaft Position (CMP) Sensor and Synchronizer - Exploded View, 3.0L
- Camshaft Position (CMP) Sensor - 3.0L
- Camshaft Synchronizer - 3.0L (2V)
- Camshaft Position (CMP) Sensor - 4.0L
- Crankshaft Position (CKP) Sensor - 2.3L
- Crankshaft Position (CKP) Sensor - 3.0L
- Crankshaft Position (CKP) Sensor - 4.0L
- Cylinder Head Temperature (CHT) Sensor - 2.3L
- Engine Coolant Temperature (ECT) Sensor - 3.0L
- Engine Coolant Temperature (ECT) Sensor - 4.0L
- Heated Oxygen Sensor (HO2S) and Catalyst Monitor Sensor - Exploded View
- Heated Oxygen Sensor (HO2S)
- Catalyst Monitor Sensor
- Idle Air Control (IAC) Valve - 2.3L
- Idle Air Control (IAC) Valve - 3.0L
- Idle Air Control (IAC) Valve - 4.0L
- Knock Sensor (KS) - 3.0L
- Knock Sensor (KS) - 4.0L
- Manifold Absolute Pressure (MAP) Sensor - 2.3L
- Mass Air Flow (MAF) Sensor
- Powertrain Control Module (PCM)
- Throttle Position (TP) Sensor - 2.3L
- Throttle Position (TP) Sensor - 3.0L
- Throttle Position (TP) Sensor - 4.0L
- Clutch Pedal Position (CPP) Switch
- Knock Sensor (KS) - 2.3L
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.