Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009EDGE SPORT, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 613 (CLIMATE CONTROL)
2009 Ford Edge Sport, FWD
Section 613 (Climate Control)
2009 Ford Edge Sport, FWDSECTION Section 613 (Climate Control)
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Air Conditioning
- Air Distribution and Filtering
- Control Components
- Electronic Manual Temperature Control
- Control System Inputs
- Climate Control Assembly (EMTC Module)
- Blower Motor Switch
- Control System Outputs
- Blower Motor Resistor
- Temperature Blend Door Actuator
- Mode Door Actuator
- Air Inlet Mode Door Actuator
- Electronic Automatic Temperature Control
- EATC Module
- Blower Motor Speed Control
- Temperature Blend Door Actuator(s)
- Heating and Ventilation
- Removal And Installation
- Air Conditioning (A/C) Compressor - 2.3L
- Air Conditioning (A/C) Compressor - 3.0L
- Air Conditioning (A/C) Evaporator Discharge Air Temperature Sensor
- Ambient Air Temperature Sensor
- Blower Motor
- Blower Motor Resistor
- Blower Motor Speed Control
- Blower Motor Switch
- Climate Control Assembly
- Clutch and Clutch Field Coil
- Compressor Manifold and Tube Assembly - 2.3L
- Compressor Manifold and Tube Assembly - 3.0L
- Condenser Core
- Evaporator Core
- Removal and Installation
- Heater Core
- Heater Core And Evaporator Core Housing
- In-Vehicle Temperature Sensor
- Mode Door Actuator - Air Inlet Door
- Mode Door Actuator - Defrost/Panel/Floor Door
- Receiver Drier
- Register - Center, Fusion/Milan
- Register - Driver and Passenger Side, Fusion/Milan
- Register - Zephyr
- Temperature Blend Door Actuator - LH
- Temperature Blend Door Actuator - RH, Dual-Zone EATC
- Thermostatic Expansion Valve
- Thermostatic Expansion Valve Manifold and Tube Assembly
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.