Torque Specifications

2009 Ford Edge Sport, FWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Intermediate shaft-to-gear pinch bolt 30 22 -
Steering gear line clamp plate bolt 18 13 -
Steering gear-to-crossmember nuts 103 76 -
Steering gear-to-crossmember studs 20 15 -
Reservoir bolt 12 9 -
Pressure line fitting-to-pump 65 48 -
Pressure line bracket-to-engine nut 7 - 62
Power steering pump bolts 25 18 -
Radiator bracket bolts 12 9 -
Condenser-to-radiator nuts 15 11 -
Inner tie rod 100 74 -
Outer tie-rod end nuts 80 59 -
Outer tie-rod end jam nut 55 41 -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.