Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009EDGE SPORT, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - PINPOINT TEST JF: INTEGRATED IGNITION COIL ON PLUG COILS A THROUGH J FAILURE THROUGH PINPOINT TEST KN: VARIABLE SPEED ELECTRIC COOLING FAN - (EXCEPT DIESEL & HYBRID)PINPOINT TEST KB: FUEL PUMP DRIVER MODULEINTRODUCTION
2009 Ford Edge Sport, FWD
Pinpoint Test Kb: Fuel Pump Driver Module: Introduction
2009 Ford Edge Sport, FWDSECTION Introduction
WARNING:
CROWN VICTORIA POLICE INTERCEPTOR VEHICLES EQUIPPED WITH FIRE SUPPRESSION SYSTEM, REFER TO FIRE SUPPRESSION SYSTEM
ARTICLE
. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
This pinpoint test is intended to diagnose the following:
- fuel pump driver module (FPDM) (9D370) and (9D372)
- FPDM power supply relay
- inertia fuel shutoff (IFS) switch (9341)
- harness circuits: B+, GND, FPC, FPM, FPM2, FP PWR, FP2PWR, FP RTN, FP2RTN, VPWR Fuel, VPWR Fuel 2, and PWRGND
- powertrain control module (PCM) (12A650)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.