Torque Specifications

2009 Ford Edge Sport, FWDSECTION Torque Specifications
TORQUE SPECIFICATIONS

Description N.m lb-ft lb-in
A/C condenser-to-radiator bolts 10 - 89
Block heater 40 30 -
Compressor-to-condenser bracket bolt 7 - 62
Coolant pump boltsa - - -
Cooling fan motor and shroud bolts 6 - 53
Degas bottle-to-fender bolt 9 - 80
Engine oil filter (1) - - -
Exhaust clamp 40 30 -
Oil cooler bracket bolt 6 - 53
Oil pan drain plug 27 20 -
Primary timing chain guide bolts 10 - 89
Primary timing chain tensioner bolts 10 - 89
Thermostat housing bolts 10 - 89
Thermostat housing cover bolts 10 - 89
Variable camshaft timing (VCT) oil control solenoid housing bolts (1) - - -
Y-pipe nuts 40 30 -
(1) Refer to the procedure in this service information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.