Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSFORD2009EDGE SPORT, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALCOOLING SYSTEM (MECHANICAL)ENGINE COOLING SYSTEMSPECIFICATIONSGENERAL SPECIFICATIONS
2009 Ford Edge Sport, FWD
General Specifications
2009 Ford Edge Sport, FWDSECTION General Specifications
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Cooling System Pressure Test Specifications | |
| Cooling System | 124 kPa (18 psi) |
| Radiator Cap Pressure Test Specification | |
| Pressure release cap | 89-124 kPa (13-18 psi) |
| Thermostat Opening Temperatures | |
| Thermostat starts to open | 86°C (187°F) |
| Thermostat fully open | 96°C (205°F) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.