Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2009CUTAWAY E250, 4R70WREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHVAC CLIMATE CONTROL SYSTEMREMOVAL AND INSTALLATIONAIR CONDITIONING (A/C) CYCLING SWITCHREMOVAL AND INSTALLATION

2009 Ford Cutaway E250, 4R70W

Removal and Installation

2009 Ford Cutaway E250, 4R70WSECTION Removal and Installation

Vehicles with 4.6L, 5.4L or 6.8L engine

Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
Remove the battery.
All vehicles
Disconnect the A/C cycling switch electrical connector.

Fig 1: Locating A/C Cycling Switch Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the A/C cycling switch.

Fig 2: Locating A/C Cycling Switch
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Install a new O-ring seal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.