SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2009CUTAWAY E250, 4R70WREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISDTC P0446: - EVAPORATIVE EMISSION SYSTEM VENT CONTROL CIRCUIT
2009 Ford Cutaway E250, 4R70W

DTC P0446: - Evaporative Emission System Vent Control Circuit

2009 Ford Cutaway E250, 4R70WSECTION DTC P0446: - Evaporative Emission System Vent Control Circuit
DTC P0446: - EVAPORATIVE EMISSION SYSTEM VENT CONTROL CIRCUIT

Description:  Monitors the canister vent (CV) solenoid circuit for an electrical failure. The test fails when the signal moves outside the minimum or maximum allowable calibrated parameters for a specified canister vent duty cycle by powertrain control module (PCM) command.
Possible Causes: 
  • VPWR circuit open
  • KAPWR circuit open (vehicles equipped with engine off natural vacuum (EONV) EVAP leak check monitor)
  • CV solenoid circuit short to PWR GND or CHASSIS GND
  • Damaged CV solenoid
  • CV solenoid circuit open
  • CV solenoid circuit short to VPWR
  • CV solenoid circuit short to KAPWR (vehicles equipped with engine off natural vacuum (EONV) EVAP leak check monitor)
  • Damaged PCM
Diagnostic Aids:  To verify normal functioning, monitor the EVAP canister vent solenoid signal PID EVAPCV and the signal voltage (PCM control side). With the valve open, EVAPCV indicates 0% duty cycle and a voltage approximately equal to battery voltage. When the valve is commanded fully closed, EVAPCV indicates 100% duty cycle, and a minimum voltage drop of 4 volts is normal. Output test mode (OTM) may be used to switch output on/off to verify function.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test HX .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.