Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Ford Ranger 2WD L4-2.3LFACTORY OEM SERVICE PROCEDURE
System Specifications
Cylinder Head Bolts
NOTE: The cylinder head bolts are torque-to-yield and must not be reused. New cylinder head bolts must be installed.
Stage 1 5 Nm (44 lb-inch)
Stage 2 15 Nm (11 lb-ft)
Stage 3 45 Nm (33 lb-ft)
Stage 4 additional 90 degrees
Stage 5 additional 90 degrees

Head face flatness 0.1 mm/general 0.05 mm/200 x 200 (0.0003 in/general) (0.0019 in/7.87 x 7.87)
Intake manifold bolts 18 Nm (13 lb-ft)
Camshaft Bearing Cap Bolts:
Stage 1: Tighten the camshaft bearing bolt caps one turn at a time until tight.
Stage 2 7 Nm (62 lb-inch).
Stage 3 16 Nm (12 lb-ft).

Camshaft Gear/Sprocket Torque 72 Nm (53 lb-ft)
Exhaust manifold-to-cylinder head studs 17 Nm (13 lb-ft)
Exhaust manifold nuts 54 Nm (40 lb-ft)
NOTE: The cylinder head bolts are torque-to-yield and must not be reused. New cylinder head bolts must be installed.
Stage 1 5 Nm (44 lb-inch)
Stage 2 15 Nm (11 lb-ft)
Stage 3 45 Nm (33 lb-ft)
Stage 4 additional 90 degrees
Stage 5 additional 90 degrees
Head face flatness 0.1 mm/general 0.05 mm/200 x 200 (0.0003 in/general) (0.0019 in/7.87 x 7.87)
Intake manifold bolts 18 Nm (13 lb-ft)
Camshaft Bearing Cap Bolts:
Stage 1: Tighten the camshaft bearing bolt caps one turn at a time until tight.
Stage 2 7 Nm (62 lb-inch).
Stage 3 16 Nm (12 lb-ft).
Camshaft Gear/Sprocket Torque 72 Nm (53 lb-ft)
Exhaust manifold-to-cylinder head studs 17 Nm (13 lb-ft)
Exhaust manifold nuts 54 Nm (40 lb-ft)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
