2008 Ford Ranger 2WD L4-2.3LFACTORY OEM SERVICE PROCEDURE

Spark Plug: Service and Repair

SPARK PLUGS

Exploded View


Factory service manual diagram





Removal and Installation

CAUTION: Spark plug wires must be connected correctly. Failure to follow this instruction may result in poor engine performance.

1. If necessary, detach the spark plug wire.


Factory service manual diagram





2. Disconnect the spark plug wire from the spark plug by slightly twisting while pulling upward.


Factory service manual diagram





3. NOTE: Remove foreign material with compressed air.

Remove the spark plug.
- To install, tighten to 12 Nm (9 lb-ft).

4. Inspect the spark plugs.
5. Check and adjust the spark plug gap as necessary.


Factory service manual diagram





6. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.