2008 Ford Mustang V8-5.4L SCFACTORY OEM SERVICE PROCEDURE

Rear Subframe: Service and Repair




Support Braces - Rear


Support Braces - Rear:

Factory service manual diagram





Removal

NOTE: The 2 rear support braces must be removed and installed at the same time.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove and discard the 4 rear support brace bolts (rear).
3. Remove and discard the 2 rear support brace bolts (upper).
4. Remove and discard the 4 rear support brace bolts (front).
5. Remove and discard the 2 rear support brace bolts (center to frame), and remove the 2 rear support braces.

Installation

NOTE:
- The 2 rear support braces must be removed and installed at the same time.
- All bolts must be started by hand before final tightening.

1. Position the LH and RH rear support braces.
1 Install the 2 rear support brace bolts (front).
2 Position the LH and RH rear support braces.
3 Install the 2 rear support brace bolts (front).


Factory service manual diagram





2. Install the 4 rear support brace bolts.
3. Install the 2 rear support brace bolts (center to frame).
4. Install the 2 rear support brace bolts (upper).
5. Tighten the bolts in the sequence shown.
- Tighten the 4 rear support brace bolts (front) to 63 Nm (46 lb-ft).
- Tighten the 4 rear support brace bolts (rear) to 63 Nm (46 lb-ft).
- Tighten the 2 rear support brace bolts (center-to-frame) to 63 Nm (46 lb-ft).
- Tighten the 2 rear support brace bolts (upper) to 25 Nm (18 lb-ft).


Factory service manual diagram



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.