Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Ford Explorer 2WD V8-4.6LFACTORY OEM SERVICE PROCEDURE
Piston Ring, Engine
Piston Rings
End gap
Top 0.15-0.30 mm (0.006-0.012 in)
Intermediate 0.25-0.50 mm (0.0098-0.0197 in)
Oil control 0.15-0.65 mm (0.0059-0.0256 in)
Ring groove width
Top 1.52-1.54 mm (0.0598-0.0606 in)
Intermediate 1.52-1.54 mm (0.0598-0.0606 in)
Oil control 3.030-3.056 mm (0.1193-0.1203 in)
Ring width
Top and intermediate 1.50-1.48 mm (0.0590-0.0582 in)
Ring-to-groove clearance
Top 0.020-0.060 mm (0.0008-0.0020 in)
Intermediate 0.020-0.060 mm (0.0008-0.0020 in)
End gap
Top 0.15-0.30 mm (0.006-0.012 in)
Intermediate 0.25-0.50 mm (0.0098-0.0197 in)
Oil control 0.15-0.65 mm (0.0059-0.0256 in)
Ring groove width
Top 1.52-1.54 mm (0.0598-0.0606 in)
Intermediate 1.52-1.54 mm (0.0598-0.0606 in)
Oil control 3.030-3.056 mm (0.1193-0.1203 in)
Ring width
Top and intermediate 1.50-1.48 mm (0.0590-0.0582 in)
Ring-to-groove clearance
Top 0.020-0.060 mm (0.0008-0.0020 in)
Intermediate 0.020-0.060 mm (0.0008-0.0020 in)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
