Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Ford Escape 2WD V6-3.0LFACTORY OEM SERVICE PROCEDURE
Transmission Position Sensor/Switch: Adjustments
Transmission Range (TR) Sensor Adjustment
1. Remove the battery and tray.
2. NOTE: Make sure the transaxle is in the NEUTRAL position.
Loosen the transmission range (TR) sensor bolts.
3. Using the special tool, align the TR sensor and tighten the bolts.
^ Tighten to 11 Nm (8 lb-ft).
4. Install the battery and tray.
5. Check for correct operation. The engine should start only in PARK or NEUTRAL. The reverse lamps should illuminate in the REVERSE position.
Special Tool(s):
1. Remove the battery and tray.
2. NOTE: Make sure the transaxle is in the NEUTRAL position.
Loosen the transmission range (TR) sensor bolts.
3. Using the special tool, align the TR sensor and tighten the bolts.
^ Tighten to 11 Nm (8 lb-ft).
4. Install the battery and tray.
5. Check for correct operation. The engine should start only in PARK or NEUTRAL. The reverse lamps should illuminate in the REVERSE position.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.