2008 Ford Escape 2WD V6-3.0LFACTORY OEM SERVICE PROCEDURE

Catalyst Monitor Sensor

CATALYST MONITOR SENSOR

Exploded View


Factory service manual diagram





Special Tool(s)


Special Tool(s):

Factory service manual diagram





Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 7 bolts (5 shown) and the LH splash shield.
- To install, tighten to 10 Nm (89 lb-in).


Factory service manual diagram





3. Disconnect the catalyst monitor sensor electrical connector and detach the wiring retainer(s).

4. NOTE: If necessary, lubricate the sensor threads with penetrating and lock lubricant to assist in removal.

Using the special tool, remove the catalyst monitor sensor.
- To install, tighten to 48 Nm (35 lb-ft).


Factory service manual diagram





5. NOTE: Apply a light coat of anti-seize lubricant to the threads of the catalyst monitor sensor.

To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.