Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Sable and 2005 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the integrated control panel. For additional information, refer to CLIMATE CONTROL ASSEMBLYΒ .
- Remove the right-side lower instrument panel insulator.
- Open the glove compartment. Pressing the tabs inward, lower the glove compartment towards the floor.
- Remove the screw.
- Remove the screw.
- Disconnect the remote climate control (RCC) module electrical connector.
- Remove the two nuts. Disconnect the plenum vacuum harness. Remove the RCC module (18C612).
- To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
