Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Taurus SEFACTORY OEM SERVICE PROCEDURE
Section 276 (HVAC System - Control Components)
WARNING: This page is about a different car, the 2005 Mercury Sable and 2005 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Control Components - Manual Climate Control
- Control Components - Electronic Automatic Temperature Control (EATC)
- Diagnosis And Testing
- Removal And Installation
- Climate Control Assembly
- Remote Climate Control Module
- Blower Motor Switch
- Temperature Control Switch
- Function Selector Switch
- Ambient Air Temperature Sensor
- In-Vehicle Temperature Sensor
- Sunload Sensor
- Air Discharge Temperature Sensor
- Temperature Blend Door Actuator
- Blower Motor Resistor
- Blower Motor Speed Control
- Vacuum Control Motor - Air Inlet Door
- Vacuum Control Motor - Panel/Floor Door
- Vacuum Control Motor - Defroster Door
- Vacuum Control Motor - Floor Console Register Duct Door
- Vacuum Reservoir
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
