Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 9 (AUTOMATIC TRANSMISSION EXTERNAL CONTROLS)GENERAL PROCEDURESSELECTOR LEVER CABLE ADJUSTMENT
2007 Ford Fusion SEL, 2.3 Z, Standard
Selector Lever Cable Adjustment
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Selector Lever Cable Adjustment
WARNING: This page is about a different variant/trim than selected.
6-speed transaxle
- Vehicles equipped with a 3.5L engine, remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.5L .
- Disconnect the selector lever cable end from the manual control lever.
- Place the manual control lever in DRIVE.
- Place the manual control lever in PARK.
- Move the manual control lever counterclockwise 3 detents to the DRIVE position.
- Disconnect the selector lever cable end from the manual control lever.
FNR5 transaxle
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.