Power Transfer Unit (PTU)

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Power Transfer Unit (PTU)
WARNING: This page is about a different variant/trim than selected.
Material

Item Specification
Motorcraft SAE 75W-140 Synthetic Rear Axle Lubricant
XY-75W140-QL (US); CXY-75W140-1L (Canada)
WSL-M2C192-A
Fig 1: Exploded View Of Power Transfer Unit (PTU) With Torque Specifications
GF0030133Courtesy of FORD MOTOR CO.
Item Part Number Description
1 7B652 Compression seal
2 W500724 Power transfer unit (PTU)-to-support bracket bolts (2 required)
3 W500724 PTU support bracket-to-engine block bolt (3 required)
4 7A444 PTU support bracket
5 W500741 PTU-to-transaxle bolts (5 required)
6 7251 PTU
    NOTE: A new compression seal must be installed whenever the power transfer unit (PTU) is removed from the vehicle.
  1. Using a suitable tool, install the new compression seal.
  2. Fig 2: Identifying Compression Seal
    GF0030132Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.