Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 996 (EXHAUST SYSTEM)SPECIFICATIONSTORQUE SPECIFICATIONS
2007 Ford Fusion SEL, 2.3 Z, Standard
Torque Specifications
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Catalytic converter bracket bolts | 25 | 18 | - |
| Catalytic converter manifold nuts (2.3L and Hybrid) | 47 | 35 | - |
| Catalytic converter manifold nuts (3.0L) | 25 | 18 | - |
| Catalytic converter manifold studs (2.3L) | 17 | 13 | - |
| Catalytic converter manifold studs (3.0L) | 11 | 8 | - |
| Exhaust catalytic converter nuts | 47 | 35 | - |
| Exhaust flexible pipe nuts | 25 | 18 | - |
| Exhaust gas recirculation (EGR) tube nut | 40 | 30 | - |
| Exhaust Y-pipe nuts (3.0L) | 47 | 35 | - |
| Heat shield bolts | 10 | - | 89 |
| Heat shield clamps | 7 | - | 62 |
| Heated oxygen sensor (HO2S) | 47 | 35 | - |
| Resonator nuts | 47 | 35 | - |
| U-bolt clamp assembly nuts | 47 | 35 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.