SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 983 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DTC DIAGNOSISP061C - INTERNAL CONTROL MODULE ENGINE RPM PERFORMANCE
2007 Ford Fusion SEL, 2.3 Z, Standard

P061C - Internal Control Module Engine Rpm Performance

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION P061C - Internal Control Module Engine Rpm Performance
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P061C - INTERNAL CONTROL MODULE ENGINE RPM PERFORMANCE

Description:  Indicates a calculation error occurred in the powertrain control module (PCM).
Possible Causes: 
  • Crankshaft position (CKP) sensor circuit is open or short
  • CKP sensor circuit intermittent
  • Damaged CKP sensor
  • Camshaft position (CMP) sensor circuit is open or short
  • CMP sensor circuit intermittent
  • Damaged CMP sensor
  • Damaged PCM
Diagnostic Aids:  Verify correct operation of the CKP and CMP sensors and related circuits.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All   - - refer to PINPOINT TEST QE .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.