Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 973 (ENGINE)GENERAL PROCEDURESVALVE CLEARANCE CHECK
2007 Ford Fusion SEL, 2.3 Z, Standard
Valve Clearance Check
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Valve Clearance Check
WARNING: This page is about a different car, the 2007 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the valve covers. For additional information, refer to Valve Cover - LH and Valve Cover - RH .
- Use a feeler gauge to measure the clearance of each valve and record its location. A mid-range clearance is the most desirable:
- Intake: 0.15-0.25 mm (0.006-0.01 in)
- Exhaust: 0.300-0.400 mm (0.0118-0.0157 in)
NOTE:
The valve clearance must be measured with the camshaft at base circle. The engine will have to be rotated with the crankshaft pulley bolt to bring each valve to base circle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.