Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 925 (EXTERIOR LIGHTING SYSTEM)
2007 Ford Fusion SEL, 2.3 Z, Standard
Section 925 (Exterior Lighting System)
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Section 925 (Exterior Lighting System)
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnostic Tests
- Headlamps
- Notes
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: Both Headlamps Are Inoperative
- Pinpoint Test B: The Low Beams Are Inoperative
- Pinpoint Test C: The High Beams Are Inoperative
- Pinpoint Test D: One Low Beam Headlamp Is Inoperative
- Pinpoint Test E: One High Beam Headlamp Is Inoperative
- Pinpoint Test F: The Headlamps Are On Continuously
- Pinpoint Test G: The Flash-To-Pass Feature Is Inoperative
- Autolamps
- Stoplamps
- Turn Signal and Hazard Lamps
- Notes
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Parking, Rear and License Plate Lamps
- Fog Lamps
- Reversing Lamps
- Trailer Lamps
- Daytime Running Lamps (DRL)
- Headlamps
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.