Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 924 (WIPER SYSTEM AND WASHER SYSTEM)GENERAL PROCEDURESWIPER BLADE AND PIVOT ARM ADJUSTMENT - WINDSHIELD
2007 Ford Fusion SEL, 2.3 Z, Standard
Wiper Blade and Pivot Arm Adjustment - Windshield
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Wiper Blade and Pivot Arm Adjustment - Windshield
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Cycle and park the windshield wipers
- Verify that the RH and LH wiper blades are located at the specified position.
- If not within specification, remove the nuts and the windshield wiper pivot arms and reposition them to the correct locations.
- To install, tighten to 35 Nm (26 lb-ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.