Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 924 (WIPER SYSTEM AND WASHER SYSTEM)DESCRIPTION AND OPERATIONWIPERS AND WASHERS
2007 Ford Fusion SEL, 2.3 Z, Standard
Wipers and Washers
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Wipers and Washers
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
The windshield wiper and washer system consists of the following:
- Windshield wiper blade
- Windshield wiper pivot arm
- Windshield wiper mounting arm and pivot shaft
- Windshield wiper motor
- Windshield washer reservoir
- Windshield washer pump
- Windshield washer nozzle jet
- Multi-function switch
- Smart junction box (SJB)
NOTE:
The smart junction box (SJB) may also be identified as the generic electronic module (GEM).
The rear window wiper and washer system consists of the following:
- Rear window wiper blade
- Rear window wiper arm
- Rear window wiper motor
- Multi-function switch
- Windshield washer reservoir
- Rear window washer pump
- Rear window washer hose
- Rear window washer hose check valve
- Rear window washer nozzle jet
- SJB
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.