Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 706 (ENGINE - 4.2L - F-150)IN-VEHICLE SERVICINGENGINE SUPPORT INSULATORSLH SIDE
2007 Ford Fusion SEL, 2.3 Z, Standard
LH side
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION LH side
WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the bolts and the LH engine support insulator.
- Apply Threadlock 262 to the bolts threads prior to installation.
- To install, tighten to 115 Nm (85 lb-ft).
CAUTION:
Clean the engine support insulator-to-bracket mating surfaces and the bolt holes in the bracket of any dirt or foreign material prior to installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.