Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 706 (ENGINE - 4.2L - F-150)IN-VEHICLE SERVICINGENGINE FRONT COVERNOTES
2007 Ford Fusion SEL, 2.3 Z, Standard
Engine Front Cover: Notes
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Material
| Item | Specification |
|---|---|
| Motorcraft Metal Surface Prep ZC-31 |
- |
| Motorcraft SAE 5W-20 Premium Synthetic Blend Motor Oil XO-5W20-QSP (US); Motorcraft SAE 5W-20 Super Premium Motor Oil CXO-5W20-LSP12 (Canada); or equivalent |
WSS-M2C930-A |
| Silicone Gasket and Sealant TA-30 |
WSE-M4G323-A4 |
| Silicone Gasket Remover ZC-30 |
- |
| Thread Sealant with PTFE TA-24 |
WSK-M2G350-A2 |
| Item | Part Number | Description |
|---|---|---|
| 1 | 14A464 | Crankshaft position (CKP) sensor electrical connector |
| 2 | N804601 | Oil pan bolts (2 required) |
| 3 | W701621 | Cap screw |
| 4 | N804839 | Bolt |
| 5 | N805112 | Stud bolts |
| 6 | 6019 | Engine front cover |
| 7 | 6020 | Engine front cover gasket |
| 8 | N804853 | Studs (2 required) |
| 9 | N805757 | Studs (2 required) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.