Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Check Messages (RESET button)
By pressing the RESET button on the message center switch, the message center cycles through each of the system check messages being monitored. For each of the monitored systems, the message center indicates either an OK message or a warning message for 2-4 seconds.
The system check messages are:
- DOORS CLOSED
- ENGINE TEMPERATURE
- CHARGING SYSTEM
- OIL PRESSURE
- BRAKE FLUID LEVEL
- EXTERIOR LAMPS
- FUEL LEVEL
- DISTANCE TO EMPTY (DTE)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.