Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 585 (PARKING AID SYSTEM)REMOVAL AND INSTALLATIONPARKING AID MODULEREMOVAL AND INSTALLATION
2007 Ford Fusion SEL, 2.3 Z, Standard
Removal and Installation
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the package tray trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Remove the LH C-pillar trim panel. For additional information, refer to REMOVAL AND INSTALLATION FIVE HUNDRED, MONTEGO or REMOVAL AND INSTALLATION FREESTYLE .
- If replacing the parking aid speaker only, proceed as follows:
- Disconnect the parking aid speaker electrical connector.
- Disengage the parking aid speaker clips.
- Remove the parking aid speaker.
- If replacing the parking aid module, proceed as follows:
- Disconnect the electrical connectors.
- Remove the parking aid module push pins.
- Remove the parking aid module.
- To install, reverse the removal procedure.
Sedan
Wagon
All vehicles
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.