Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 418 (INFORMATION CENTER)GENERAL PROCEDURESCOMPASS ZONE ADJUSTMENT
2007 Ford Fusion SEL, 2.3 Z, Standard
Compass Zone Adjustment
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Compass Zone Adjustment
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Determine which magnetic zone you are in for your geographic location.
- Turn the ignition switch to the ON position.
- Locate the reset button on top of the compass sensor module mounted behind the mirror. Press and hold the reset button on the compass module for approximately 5 seconds until COMPASS ZONE XX is displayed in the message center display.
- Press the reset button repeatedly until the correct zone setting for your geographic location is displayed.
- After 4 seconds, ZONE XX IS SET appears in the in the message center display and the zone is now updated.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.