SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 347 (HVAC CONTROL SYSTEM)REMOVAL AND INSTALLATIONTEMPERATURE CONTROL SWITCHREMOVAL AND INSTALLATION
2007 Ford Fusion SEL, 2.3 Z, Standard

Removal and Installation

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Place the temperature selector switch in the full cold position before disengaging the temperature blend door actuator.
  1. Remove the instrument panel center finish panel. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the temperature selector gear knob.
  3. Remove the temperature selector gear screw.
  4. Press the tab and rotate the temperature selector gear counterclockwise.
    • Remove the temperature selector gear.
      Fig 1: Removing Temperature Selector Gear
      G04621676Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
    • Place the temperature selector switch in the full cold position before installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.