Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 299 (REAR VIEW MIRROR SYSTEM)DIAGNOSIS AND TESTINGREAR VIEW MIRRORSINSPECTION AND VERIFICATION
2007 Ford Fusion SEL, 2.3 Z, Standard
Inspection and Verification
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Inspection and Verification
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
If equipped with fire suppression system, refer to
FIRE SUPPRESSION SYSTEM
for important safety warnings.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical or electrical damage.VISUAL INSPECTION CHART
Mechanical Electrical - Exterior rear view mirrors
- Interior rear view mirror
- Central junction box (CJB) fuse(s):
- 15 (7.5A)
- 25 (10A)
- 32 (10A)
- Circuitry
- Exterior rear view mirror control switch
- Rear window defrost switch
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the concern is not visually evident, verify the symptom and GO to SYMPTOM CHART .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.