Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 266 (AUTOMATIC TRANSMISSION)SPECIFICATIONSBAND AND CLUTCH APPLICATION CHART B
2007 Ford Fusion SEL, 2.3 Z, Standard
Band And Clutch Application Chart B
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Band And Clutch Application Chart B
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
BAND AND CLUTCH APPLICATION CHART B
| Gear | Intermediate One-Way Clutch | Planetary One-Way Clutch | Solenoid States | ||||
|---|---|---|---|---|---|---|---|
| Drive | Coast | Drive | Coast | SSA | SSB | TCC | |
| Park | ON | OFF | HD | ||||
| Reverse | NE | ON | OFF | HD | |||
| Neutral | ON | OFF | HD | ||||
| 1st Gear Manual Low | H | ON | OFF | HD | |||
| 2nd Gear Manual | H | OFF | OFF | EC | |||
| 1st Gear (D) (Overdrive) | H | OR | ON | OFF | HD | ||
| 2nd Gear (D) (Overdrive) | H | OR | OR | OFF | OFF | EC | |
| 3rd Gear (D) (Overdrive) | OR | OR | OFF | ON | EC | ||
| 4th Gear (D) (Overdrive) | OR | ON | ON | EC | |||
| HD = Hydraulically Disabled NE = No Effect H = Hold EC = Electronically Controlled OR = Overrunning |
|||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.