Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 206 (VIDEO SYSTEM)REMOVAL AND INSTALLATIONDIGITAL VERSATILE DISC (DVD) PLAYERREMOVAL AND INSTALLATION
2007 Ford Fusion SEL, 2.3 Z, Standard
Removal and Installation
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 4 DVD player screws.
- Pull down on the sides of the DVD player and disengage the clips from the bracket.
- Disconnect the electrical connector and remove the DVD player.
- To install, reverse the removal procedure.
NOTE:
Open the video display door to access the screws.
NOTE:
The DVD player assembly must be supported while disengaging the clips.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.