SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 177 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL AND INSTALLATIONRESTRAINTS CONTROL MODULE (RCM)INSTALLATION
2007 Ford Fusion SEL, 2.3 Z, Standard

Restraints Control Module (RCM): Installation

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the RCM.
    2. WARNING: The tightening torque of the air bag restraints control module (RCM) retaining bolts is critical for correct system operation.
  2. Install the RCM bolts.
    • To install, tighten to 12 Nm (9 lb-ft).
      Fig 1: Installing RCM Bolts
      G03989904Courtesy of FORD MOTOR CO.
  3. Make sure the large RCM electrical connector position assurance lever is in the full release position before attempting to connect the connector.
    Fig 2: Identifying Connector Position Assurance Lever
    G03989905Courtesy of FORD MOTOR CO.
    4. CAUTION: Placing the large RCM electrical wiring connector into the RCM at an angle can cause bad electrical connections and damage components.
  4. Position the large RCM electrical wiring connector into the RCM.
      CAUTION: Do not push the connector to where the lever pivots and seats itself. Light pressure is needed to get the connector into position on the RCM before using the lever to fully seat the connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.