Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1568 (MANUAL TRANSAXLE)GENERAL PROCEDURESTRANSAXLE DRAINING AND FILLINGMATERIAL
2007 Ford Fusion SEL, 2.3 Z, Standard
Transaxle Draining and Filling: Material
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Material
WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Specification |
|---|---|
| SAE 75W-90 API GL-4 Gear Oil XT-4-QGL |
WSS-M2C203-A1 |
| Item | Part Number | Description |
|---|---|---|
| 1 | - | Transaxle drain plug |
| 2 | - | Transaxle fill plug |
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Remove the drain plug and drain the fluid.
- Install a new washer and the drain plug.
- Tighten to 49 Nm (36 lb-ft).
- Remove the fill plug.
NOTE:
Prior to removal, clean the area of the fill plug.
NOTE:
Do not overfill the transaxle. This may result in increased operating temperature or cause transaxle fluid to be forced out of the case.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.