Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1568 (MANUAL TRANSAXLE)DISASSEMBLYINPUT SHAFTMATERIAL
2007 Ford Fusion SEL, 2.3 Z, Standard
Input Shaft: Material
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Material
WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Specification |
|---|---|
| SAE 75W-90 API GL-4 Gear Oil XT-4-QGL |
WSS-M2C203-A1 |
| Item | Part Number | Description |
|---|---|---|
| 1 | 7025 | Bearing |
| 2 | 7017 | Input shaft |
| 3 | 7101 | 3rd gear |
| 4 | - | Double cone (part of 7Z018) |
| 5 | - | Inner cone (part of 7Z018) |
| 6 | 7Z018 | Synchronizer blocking ring (part of blocking ring set) |
| 7 | 7109 | Synchronizer blocking springs (part of 7124) |
| 8 | 7A044 | Synchronizer hub insert (part of 7124) |
| 9 | 7105 | Synchronizer hub (part of 7124) |
| 10 | 7106 | Synchronizer sleeve (part of 7124) |
| 11 | 7124 | Synchronizer hub assembly |
| 12 | 7064 | Snap ring |
| 13 | - | Double cone (part of 7Z018) |
| 14 | - | Inner cone (part of 7Z018) |
| 15 | 7110 | 4th gear |
| 16 | 7025 | Bearing |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.