Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1564 (WIPER SYSTEM & WASHER SYSTEM)GENERAL PROCEDURESWIPER BLADE AND PIVOT ARM ADJUSTMENT
2007 Ford Fusion SEL, 2.3 Z, Standard
Wiper Blade and Pivot Arm Adjustment
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Wiper Blade and Pivot Arm Adjustment
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Cycle and park the windshield wipers.
- Verify that the RH and LH wiper blades are located at the alignment marks on the glass.
- If necessary, remove the nuts and the windshield wiper pivot arms and reposition them to the correct locations.
- To install, tighten to 20 Nm (177 lb-in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.