Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1435 (SEAT SYSTEM - SEATS)SPECIFICATIONSTORQUE SPECIFICATIONS
2007 Ford Fusion SEL, 2.3 Z, Standard
Torque Specifications
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Front Seat | |||
| Inboard seat track-to-upper support assembly lift link nuts | 27 | 20 | - |
| Recliner-to-backrest bolts | 55 | 41 | - |
| Recliner-to-seat track bolts | 55 | 41 | - |
| Seat backrest pivot bolt | 45 | 33 | - |
| Seat position sensor magnet assembly bolt | 9 | - | 80 |
| Seat safety belt buckle nut | 48 | 35 | - |
| Seat track motor assembly-to-seat track bolts | 12 | - | 106 |
| Seat track motor assembly-to-seat track nuts | 14 | - | 124 |
| Seat track nut - inboard | 80 | 59 | - |
| Seat track-to-cushion frame bolts | 20 | - | 177 |
| Seat track-to-floor bolts | 25 | 18 | - |
| Seat track-to-floor nut - outboard | 25 | 18 | - |
| Side air bag module nuts | 7 | - | 62 |
| Rear Seat | |||
| Seat backrest-to-floor nuts | 55 | 41 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.