Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1411 (WHEELS & TIRES)GENERAL PROCEDURESTIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR ACTIVATION
2007 Ford Fusion SEL, 2.3 Z, Standard
Tire Pressure Monitoring System (TPMS) Sensor Activation
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Tire Pressure Monitoring System (TPMS) Sensor Activation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Activation Tool, Tire Pressure Monitor | 204-363 |
NOTE:
The tire pressure sensors will go into a "sleep mode" after 30 minutes of inactivity to conserve battery power. The sensors do not transmit information while in sleep mode. It will be necessary to wake them up so they will transmit the latest tire pressure information.
- Turn the ignition switch to the ON position.
- Position the Tire Pressure Monitor Activation Tool toward the LF tire valve stem.
- Press the test button on the Tire Pressure Monitor Activation Tool to activate the sensor, activate the sensor at least 2 times.
- Repeat Steps 2 and 3 for the remaining tires.
- If the Tire Pressure Monitoring System (TPMS) indicator remains illuminated after adjusting and activating each sensor, refer to the appropriate Symptom Chart under DIAGNOSTIC TESTS .
NOTE:
The Tire Pressure Monitor Activation Tool will provide feedback in the form of a flashing green light and a beep sound for each successful response from a tire pressure sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.