Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 141 (ENGINE COOLING SYSTEM)SPECIFICATIONSGENERAL SPECIFICATIONS
2007 Ford Fusion SEL, 2.3 Z, Standard
General Specifications
2007 Ford Fusion SEL, 2.3 Z, StandardSECTION General Specifications
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Cooling System Capacities | |
| Cooling system capacity w/aux heater | 12.0 liters (3.17 gal) |
| Cooling system capacity w/o aux heater | 10.0 liters (2.65 gal) |
| Coolant Type | |
| Motorcraft Premium Gold Engine Coolant VC-7-A (in California, Oregon and New Mexico VC-7-B, in Canada CVC-7-A) or equivalent (yellow color) | WSS-M97B51-A1 |
| Other Chemicals | |
| Premium Cooling System Flush VC-1 | ESR-M14P7-A |
| Cooling System Stop Leak Pellets VC-6 | WSS-M99B37-B6 |
| Cooling System Pressure Test Specifications | |
| Cooling system | 124 kPa (18 psi) |
| Radiator Cap Pressure Test Specifications | |
| Pressure release cap | 89-124 kPa (13-18 psi) |
| Thermostat Opening Temperatures | |
| Starts to open | 82°C (180°F) |
| Fully open | 95°C (203°F) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.