Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2007FUSION SEL, 2.3 Z, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1364 (HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS)REMOVAL AND INSTALLATIONLIFTGATE WINDOW LATCHREMOVAL AND INSTALLATION

2007 Ford Fusion SEL, 2.3 Z, Standard

Removal and Installation

2007 Ford Fusion SEL, 2.3 Z, StandardSECTION Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the liftgate window glass is in the raised position.

Remove the liftgate trim panel. For additional information, refer to LIFTGATE TRIM PANEL .
Disconnect the liftgate window latch ajar switch electrical connector.

NOTE: Mark the position of the liftgate window latch prior to removing the liftgate window latch bolts.

Remove the 2 bolts and the liftgate window latch.
- To install, tighten to 12 Nm (106 lb-in).
  
  Fig 1: Locating Liftgate Window Latch With Bolts
  Courtesy of FORD MOTOR CO.

NOTE: The liftgate window latch must be checked to make sure the latch is installed and aligned correctly.

To install, reverse the removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.